Universal 3D Printed spout

I created these pouring spouts for the use on my one pound black powder cans to make it easier to fill your powder horn. You are required to drill a 3/8" diameter hole in the lid of your container. I also supply a small spanner wrench for tightening the nut on the inside of the cap. The hole thru the spout is 1/4” so the powder flows nicely.

TIGHTEN LIGHTLY THESE PARTS ARE PLASTIC AND WILL BREAK IF OVER TIGHTENED.

You will receive one spout with cap and nut, also a wrench for tightening the nut. 

POWDER CAN NOT INCLUDED